FAA oversaw and signed off on repair work before nationwide ground stop: Washington Post
Officials are examining whether a faulty router or contractor error triggered the outage that disrupted more than 4 hours of domestic departures.
- On Friday, an FAA official in Arkansas oversaw and approved the replacement of a router and copper wiring with fiber-optic cables, signing off on the work just eight minutes before the national ground stop.
- Transportation Secretary Sean Duffy reported the replaced Juniper router was faulty, flooding the network with over 1,000 connection attempts every few seconds and overwhelming air-ground communications.
- During a Tuesday news conference, Duffy questioned whether "incompetence" by L3Harris caused the 4.5-hour outage, stating he wanted the contractor to "hire better minds" for infrastructure work.
- FAA and L3Harris officials are examining the router to determine whether hardware defects or installation error caused the failure; L3Harris has paused Juniper deployments despite dozens remaining active.
- The fact that an FAA official greenlit the Arkansas upgrade complicates Duffy's efforts to blame L3Harris solely, raising questions about agency oversight during the modernization push.
21 Articles
21 Articles
Exclusive: ‘There was no monitoring.’ Sources say FAA had little oversight of work that led to nationwide ground stop
On the morning of last week’s historic nationwide ground stop, an FAA technician escorted a private contractor from L3Harris into a remote radio communications site for air traffic control centers in south Arkansas, to replace a decades-old router.
FAA official was in Arkansas just 8 minutes before nationwide ground stop, report reveals
An official with the U.S. Federal Aviation Administration (FAA) was on the ground in Arkansas when new telecommunications wires were installed just eight minutes before Friday’s nationwide ground stop, according to a report by The Washington Post. The official oversaw the work, which involved replacing a router and swapping old copper wires for new fiber-optic cables. The work was part of a national FAA effort to upgrade the airline industry’s c…
8 Minutes Before System Began to Fail, FAA Signed Off on Upgrade
The massive aviation timeout that froze flights nationwide for more than four hours on Friday cam just minutes after the FAA approved a fix that went live at a tiny facility in rural Arkansas, reports the Washington Post. A contractor for L3Harris Technologies had been switching air-traffic communications from aging...
Coverage Details
Bias Distribution
- 55% of the sources are Center
Factuality
To view factuality data please Upgrade to Premium




















